Electroplating Rectifiers are used as a direct current source in areas such as purification of metals and chemical raw material production. Mak Plus Power Systems produce different electroplating rectifiers with various voltage and current values depending on the material you want to electroplate. The name of the series is REC-MAK Electroplating rectifiers and electrical DC supply for your need. Since electroplating is a long process which needs high power, the rectifiers that are used for this process should be specially designed to run 24/7 with a high power co-efficiency and yield. Mak Plus Power Systems offers you many options to design the most well suited rectifier for your electroplating process. Mak Plus Power Systems’ electroplating rectifiers can come with either thyristor controlled systems or switch mode systems. Depending on the capacity of the electroplating rectifier, you can choose between a device with air cooling or water cooling depends on your easy service and application. In some applications, the rectifier capacity can reach over 10000 Amper and till 60Volt in these applications, high voltage fed rectifiers are used. The electroplating rectifier is a plating rectifier for metal plating solution that is needed for all sector.
Mak Plus Power Systems offer you electroplating rectifiers that are equipped with the latest AC power control unit. This unit ensures that the chances of malfunction are minimized and it also increases the functions of the rectifier. With this new AC drive unit, the possible errors are prevented even before they occur.
Therefore these rectifiers can endure even the most difficult of circumstances without being concerned about problems that can occur about safety. The new drive system can work with a remote control and it has an automation system.
These electroplating rectifiers come with a timer which enables you to set it to work for either a limited time or continuously. When it is set to work for a limited time, the rectifier works until it reaches the desired values and then it stops automatically. At the end of the process, the operator gets a warning. When it is set to work continuously, the rectifier keeps functioning normally until the operator interrupts the process when it’s desired to.
The plating rectifiers Mak Plus Power Systems produce have an ampere per hour calculation feature which allows you to receive the most reliable data that was obtained during the process. You can also adjust the plating process by ampere/hour instead of using a deadline. The operator panel views both the coating process and the sum of all the transactions that has been made. This system allows you to add chemicals to the pool automatically. Mak Plus Power Systems understands how important the chemical concentration is, especially in critical baths, therefore we offer you the RC-MAK series electroplating rectifiers that enables you to control the chemicals as well as obtain information about the system from Germany.
The rectifiers we offer come with a selective working program. Normally in most of the plating pools, a selective working program is used in order to remove unwanted metals from the pool, but this process has to be done either manually or with an external device. With MRS electroplating rectifiers that Mak Plus Power Systems offer you, this process is done automatically, using the selective program. When the operator starts the process, the output voltage keeps increasing from zero, and then turns back to zero again. This process can be repeated indefinitely or for a limited time according to your needs and wishes. This way, you can spare your work force.